ACU-200 Two Door Slave Control Panel

  General Features:
  • A slave control panel to NCU Network Control Panel ACU-200 can execute basic access control in case of failure of NCU 2 doors, 4 external reader controller Auto communication status detection on upper layer control
  • panel ( NCU ) and auto switch to off-line mode after 10 seconds communication failure 2 off-line door open modes (temporary card verification or
  • swipe card) NCU network control panel auto time calibration on ACU-200
  • access control panel and readers Each door max. 256 events storage under off-line mode Synchronized operation with upper layer controller (NCU) Duress real time alarm Door Monitoring Configurable disarm codes from reader
  • CRC ( Cyclic Redundancy Checker ) to ensure data accurracy.
   System Architecture:

  Specifications:
Processor
 8 Bit
Memory
 32K
Input ports
4 Sensor(Door Sensor x2,
Exit Button x 2)
Output ports
4 Relay(Electronic Lock x 2
Alarm x 2)
Cardholders
 1024(max)
LED Indicator
Power x 1, Output Status x 4
COMM. x 2, Status x 1
Device ID Setting
DIP Switch (Hardware)
Reader ports
ABA-Track2 / Wiegand26 / RS-485 x 2
*Magnetic Type
ISO3554 Standard Track
Scanning speed:3~40ips
*Proximity Type
RF 125KHz, Effective range:8~10cm
*Mifare Type
RF 13.56MHz, Effective range:5cm
*HID Type
Wiegand 26
Operating Voltage
DC 12V / 500mA(Excluding Reader)
Power Consumption
6W (max) (Excluding Readers)
Comm. Interface
RS-485
Comm. Baud Rate
19,200 bps-N-8-1
Operating Temp.
-10¢X C ~ 55¢X C / 32¢X F ~ 113¢X F
Relative Humidity
20% ~ 95% (Non Condensing)
Dimensions
 210mm(L) x 150mm(W) x 28.5mm(H)
Weight
 385g